Cable Box Setup; Signal Type; Rf Output - Go-Video DV1040 User Manual

Channel Settings

Signal Type

Specifies whether the DVD+VCR is
connected to an antenna or cable TV
source.
1
Press VCR, then press SETUP.
2
Select Channel Set > Signal Type.
3
Choose from the following:
Antenna - Select if the DVD+VCR is
connected to an antenna.
Cable - Select if the DVD+VCR is con-
nected to a cable TV source.
4
When finished, press SETUP to exit.

Cable Box Setup

Allows you to specify the channel or
input the DVD+VCR uses to view an
external cable box or satellite receiver.
1
Press VCR, then press SETUP.
2
Select Channel Set > Cable Box Setup.
3
Set the cable box channel/input:
• Use  to select the cable box
output channel (usually 3 or 4).
• Use the TV VIEW button on the re-
mote to select the Video 1 (rear) or
Video 2 (front) input.
4
When finished, press SETUP to exit.

RF Output

Sets the RF Output Channel (the chan-
nel you set on your TV to view the
DVD+VCR).
1
Press VCR, then press SETUP.
2
Select Channel Set > RF Output.
3
Set the RF Output Channel to 3 or 4.
4
Set your TV to the channel you se-
lected in step 3.
5
When finished, press SETUP to exit.
24
DVD+VCR User's Guide
(continued)