Washing Procedure - Daewoo DW-500M Instruction Manual

WASHING PROCEDURE

TO WASH
! Before starting washing, check followings.
Lay the drain hose down toward a sink hole.
(In case of NO DRAIN PUMP model)
Place the drain hose in sink or bath.
(In case of DRAIN PUMP model)
Connect the power cord to the power supply outlet.
@ Set the WASH SELECTOR to "WASH · RINSE".
TO SPIN DRY
! Transfer the clothes into the spin basket and arrange it
evenly.
@ Be sure to put the safety cover and close the inner lid.
TO RINSE
! Set the WASH SELECTOR to "WASH · RINSE".
@ Supply the proper amount of water as not to overflow
the top of the washing tub.
# Set the TIMER 2~3 minutes.
OVER FLOW RINSE
! Set the WASH SELECTOR to "WASH · RINSE".
@ Keep suppling water. (Adjust water pressure to ensure that
the amount of supplied does not exceed the amount of drain.)
# Set the TIMER 6~8 minutes.
# Fill water in the wash tub to the desired water
level and add detergent. (see page 5)
$ Put laundry in the wash tub.
% Set the WASH TIMER 1~15 minutes.
^ After washing, set the WASH SELECTOR to "DRAIN"
for drain and set the TIMER to the proper time.
# Close the spin dryer lid.
$ Set the SPIN SELECTOR to "SPIN".
% Set the TIMER 1~5 minutes.
$ To drain the water, set the WASH SELECTOR to
"DRAIN" and set the TIMER to the proper time.
% Repeat this cycle until drain water is clean.
(2~3 cycles)
$ As soon as the TIMER shuts off or the rinsing
water become clear, turn off the water tap.
% To drain the water, set the WASH SELECTOR to
"DRAIN" and set the TIMER to the proper time.
3