Advertisement
WASHING PROCEDURE
TO WASH
! Before starting washing, check followings.
Lay the drain hose down toward a sink hole.
(In case no drain pump model)
Place the drain hose in sink or bath.
(In case drain pump model)
Connect the water supply hose and open the water tap.
Connect the power cord to the power supply outlet.
@ Set the WASH ACTION SELECTOR to the desired mode.
# Set the VALVE SELECTOR to "WASH • RINSE".
(In case drain pump model "WASH • RINSE" OR "OFF")
TO RINSE
! Set the VALVE SELECTOR to "WASH • RINSE".
(In case drain pump model "WASH • RINSE" or "OFF")
@ Supply the proper amount of water.
# Set the WASH TIMER 2~3 minutes.
TO OVER FLOW RINSE
! Set the VALVE SELECTOR to "WASH • RINSE".
(In case drain pump model "WASH • RINSE" or "OFF")
@ Keep suppling water. (Adjust water pressure to ensure
that the amount of supplied dose not exceed the
amount of drain.)
# Set the WASH TIMER 6~8 minutes.
TO SPIN RINSE(ADDITIONAL COURSE)
After rinsing you can select this course for more effective rinse.
! Load the laundry evenly into the spin basket.
@ Cover the laundry with safety cover and close the inner lid.
# Close the spin dryer lid.
$ Set the WATER GUIDE KNOB to "SPIN".
TO SPIN DRY
! Transfer the landry into the spin basket and arrange it evenly.
@ Be sure to put the safety cover and close the inner lid.
# Close the spin dryer lid.
$ Set the SPIN TIMER 1~5 minutes.
TO WASH
$ Set the WATER GUIDE KNOB to "WASH".
% Fill water in the wash tub up to the indicated water
level and add detergent. (See page 5)
^ Load laundry in the wash tub.
& Put the wash tub lid.
* Set the WASH TIMER 1~15 minutes.
( After washing, set the VALVE SELECTOR to "DRAIN"
for drain.
$ Drain the water.
Set the VALVE SELECTOR to "DRAIN".
% Repeat this cycle until drain water is clean.
(2~3 cycles)
$ As soon as the WASH TIMER shuts off or the rinsing
water became clear, turn off the water tap.
% Drain the water.
Set the VALVE SELECTOR to "DRAIN".
% Supply water for about 1 minute.
Adjust the water flow not to overflow to the side of the
wash tub.
^ After water supply, Set the SPIN TIMER 1~2 minutes.
& Repeat %~^, if you want.
2
Advertisement
