Programming The Remote Control - Daewoo DTQ-3062SC User Manual

The HDTV Monitor's remote control is pre-programmed to operate
your HDTV Monitor. However, you can also program the HDTV
Monitor's remote control to operate other components, such as Cable
TV BOX, or VCR.
1. Confirm that the external component is plugged in and turned off.
2. Find your component's list of code numbers from the
manufacturers Code List. (Refer to Component Codes)
3. Press and hold the "MODE" button (CATV, VCR) for the
component you are setting up until the Mode selection button
flashes.
4. Enter the 3-digit component code using the remote control number
buttons, (0~9) pointing the remote control toward the component. If
a correct code was entered, the component will turn on. (If the
component does not turn on, repeat the step 4 using another
code.)
5. Press the "Mode" button, and then, LED lamp will blink three times
and go out.
NOTE : Your component may not be compatible with the HDTV Monitor's
remote control. If this happens, you have to use your component's
own remote control to operate it.
PROGRAMMING THE REMOTE CONTROL
Mode buttons
Numer buttons
56