Table of Contents
Advertisement
Receiving Stereo or SAP Mode Programs
LWhen transmission signal is low or
broadcasting condition is not good,
sound might be cut off temporarily.
This type of malfunctioning is not
caused by the TV set. In this case,
press "MTS" button, and shift the
mode into "Mono" .
LThe Second Audio Program (SAP)
settings offers you the option of
listening to either of two separate
audio programs , such as a second
language broadcast.
35
1.Press "MTS" button.
•Whenever this button is pressed the mode status shifts in the following sequence:
Mono
Stereo
SAP.
Mono
•Press "DISPLAY" button on the Remote Control to check the program transmission
mode.
Air 44
Mono
•When the program transmission is in stereo mode, select "Stereo" to receive the
stereo sound.
•If the quality of stereo sound is not clear, set it in "Mono"; Then, you should have
less noise.
Stereo
•When the program transmission is in "SAP" mode, select "SAP" to receive "SAP"
broadcasting.
SAP
Stereo
Mono
SAP
Advertisement
Table of Contents
