Advertisement
HOW TO OPERATE
Starting your new Refrigerator
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the inside with
a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to "7". Close the door and let the refrigerator operate for 15-20
minutes.
The freezer should then show some traces of frost.
Temperature control
You can control the inside temperature by turning the
thermostat dial. Higher numbers mean greater cooling
power, smaller numbers mean less cooling power. To
make ice cubes in the freezer compartment, set the dial
to "7". The dial does not have to be set exactly on the
numbers, but can be any place in between.
NOTE : Wait 3 to 5 minutes before restarting if you unplug the machine. Unit
may fail to operate properly if restarted too quickly.
How to defrost
Defrost the refrigerator when the frost accumulated on the evaporator is about
5mm(1/5inch) thick.
Set the thermostat dial to "OFF". Remove foods. Keep drip tray in place. Defrosting usually
takes a few hours. To defrost quickly remove all foods from the refrigerator and leave door
open. Never use a knife or other metal instrument to remove ice/frost from the evaporator.
After defrosting empty water from drip tray, return the thermostat dial to the desired position
to start refrigerating again.
6
2
TEMPERATURE
CONTROL
3
HOW TO CLEAN
Cleaners: The cleaners noted below are available. Never use harsh, abrasive cleaners, heavy-
duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic
waxing, use silicon wax.
Evaporator: When refrigerator needs defrosting turn thermostat dial to "OFF". Do not use
sharp instruments.
Refrigeration Section: Wash shelves and other removable parts in warm sudsy water,
rinse and dry. Wash interior with baking soda solution (3 table spoons to one quart of water)
or warm sudsy water, rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to desired setting.
HOW TO INSTALL
¢º Install refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door will
open for a fully usable interior. Refrigerator is not designed for recessed
installation.
¢º Select a place with strong level floor.
¢º Allow 5 inches of space between the
refrigerator's side and the wall.
5
inches
4
Advertisement
