Gas Connection - AEG 34942 G Operating And Installation Manual

Installation
On the end of the shaft, which includes the G 1/2" threaded elbow,
adjustment is fixed so that the washer is fitted between the components
as shown in the diagram. Screw the parts together without using
excessive force.

Gas Connection

Connection to the gas supply should be with either rigid or semi-rigid
pipe, i.e. steel or copper.
The connection should be suitable for connecting to RC 1/2 (1/2 BSP
male thread).
When the final connection has been made, it is essential that a thorough
leak test is carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the
hob.
It is important to install the elbow correctly, with the shoulder on
the end of the thread, fitted to the hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas.
16
FO 0264
A) End of shaft with nut
B) Washer
C) Elbow
FO 0814