Gas Connection - AEG HG995440XB User Manual

Gas Connection

It is necessary that the connection to the gas mains are carried out by means of an AGB
tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel) in compliance
with the regulation in force. If you use flexible metallic pipes, be careful they do not come
in touch with mobile parts or they are not squeezed. Also be careful when the hob is put
together with an oven.
The connection must be done according to regulation NBN D 5I.003.
Make sure that the gas supply pressure of the appliance obeys the recommended values.
The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut
G 1/2". All the components shown in the figure have already been assembled in the factory.
The appliance, before leaving the factory, has been tested in order to give you the best re-
sults.
1 End of shaft with nut
2 Washer
3 Elbow
Liquid gas: use the rubber pipe holder. Always engage the gasket. Then continue with the
gas connection. The flexible pipe is prepared for apply when:
– it can not get hot more than room temperature, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting edges or corners;
– it can be easily examined in order to check its condition.
The control of preservation of the flexible pipe consists in checking that:
– it does not show cracks, cuts, marks of burnings on the two ends and on its full length;
– the material is not hardened, but shows its correct elasticity;
– the fastening clamps are not rusted;
1
2
3
25
Installation