Important Safety Requirements; Location - AEG 34942 G Operating And Installation Manual

Important safety requirements

This hob must be installed in accordance with the Gas Safety
(Installation and Use) Regulations (Current Edition) and the IEE
Wiring Regulations (Current Edition).
Detailed recommendations are contained in the following British
Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and
B.S. 6891 Current Editions.
The hob should not be installed in a bed sitting room with a
volume of less than 20 m . If it is installed in a room of volume
3
less than 5 m an air vent of effective area of 110 cm is
3 2
required. If it is installed in a room of volume between 5 m and
3
10 m an air vent of effective area of 50 cm is required, while if
3 2
the volume exceeds 11 m no air vent is required.
3
However, if the room has a door which opens directly to the
outside no air vent is required even if the volume is between 5
m and 11 m .
3 3
If there are other fuel burning appliances in the same room, B.S.
5440 Part 2 Current Edition, should be consulted to determine
the requisite air vent requirements.

Location

The hob may be located in a kitchen, a kitchen/diner or bed
sitting room, but not in a bathroom or shower room.
Before making the cut out in the worktop ensure that there is a
minimum distance of 55 mm between the rear edge of the hob
and the wall.
A minimum distance of 100 mm must be left between the side
edges of the hob and any adjacent cabinets or walls.
The minimum distance combustible material can be fitted above
the hob in line with the edges of the hob is 400 mm. If it is fitted
below 400 mm. a space of 50 mm must be allowed from the
edges of the hob.
The minimum distance combustible material can be fitted
directly above the hob is 700 mm.
14