Removing The Ups Battery Assembly - NCR RealPOS 7458 Hardware Service

Removing the UPS Battery Assembly

1. Remove the Secondary Hard Disk (if present).
2. Remove the Outside UPS Battery Bracket.
a. Release the latch on the by pressing the green tab toward the
back of the terminal as shown below.
b. Slide the bracket toward the side of the terminal to disengage
the hooks.
3. Remove the batteries and disconnect the UPS Battery Cable.
4. Optional: If you need access to the Fan Cable remove the Inside
UPS Battery Bracket.
Chapter 3: Hardware Service 3-25
UPS Batteries
Release Latch
20329