Removing The Compact Flash - NCR RealPOS 7458 Hardware Service

Removing the Compact Flash

The terminal configuration determines where the Compact Flash is
mounted. It can be on the Secondary Hard Disk Bracket, the UPS
Battery Bracket, or on the chassis. All three locations contain the same
hole/slot pattern for the mounting the bracket.
1. Disconnect the Compact Flash Power Cable from the Motherboard.
2. Disconnect the Compact Flash Interface Cable (Ribbon Cable) from
the Compact Flash.
3. Remove the Compact Flash Assembly. The assembly has a hook on
the bottom end of the bracket and a snap connection standoff on
the top end. Unsnap the standoff and remove the assembly.
The card is mounted on four snap standoffs on the bracket for easy
removal.
Chapter 3: Hardware Service 3-21
Compact Flash
20332