Table of Contents
Advertisement
13-1291.fm Page 9 Wednesday, July 14, 1999 6:29 PM
2. Uncoil the loop antenna's braided
wire.
3. Flip open the pair of terminal tabs
marked
AM LOOP
the system, then insert the loop
antenna's bare wires into the ter-
minals. Then push the tabs in the
opposite direction to lock them.
(illus)
Notes:
• To avoid noise or interference, do
not place the loop antenna near a
power source or speaker cord.
• For the best reception, install the
loop antenna away from any wall.
Connecting the FM Antenna
To connect the supplied FM antenna,
flip open the pair of terminal tabs
marked
on the back of the
FM 300W
system, and insert the antenna's bare
wires into the terminals. Then push
the tabs in the opposite direction to
lock them.
on the back of
Extend and position the antenna's
wire for the best reception.
REMOVING THE CD
PROTECTION LOCK
The system has a CD protection lock
under the system's base. Installed at
the factory, the CD protection lock se-
cures the system's CD changer to pro-
tect it from damage during shipping.
To use the CD changer, you must re-
move the CD protection lock.
Caution: Be sure the power cord is
unplugged from the AC outlet before
you begin.
To remove the CD protection lock,
turn it in the direction of the arrow until
it stops, then pull it out to remove
it.Note: Save the CD protection lock
so you can use it to secure the system
if you move it.
(illus)
(one combined illus for all
following steps)
9
Advertisement
Table of Contents
