Optimus System 744 Owner's Manual page 26

13-1291.fm Page 26 Wednesday, July 14, 1999 6:29 PM
(illus)
The CD display shows the disc
number you entered in Step 2 and
the track number (next to
entered in this step. The CD
changer programs your selection.
Note: If the track number you
entered disappears before you
press , repeat Steps 2–3.
TRACK
4. Repeat Steps 2–3 to program
more selections.
Note: You must re-enter the disc
number in Step 2 even if you pro-
gram more than one track from
the same disc.
5. To play the
sequence, press
the front of the system or
the remote control. After a few
seconds, appears on the CD
display, and the first programmed
track on the first programmed CD
begins to play.
To play the previous track or the
next track in the programmed
sequence, press
or
system or
remote control.
26
) you
P
programmed
on
PLAY/PAUSE
on
SKIP/SEARCH
on the
or on the
You can use audible search dur-
ing programmed play by press-
ing and holding down
SEARCH
on the system. You
cannot use
remote control to do audible
search.
Note: When the CD changer
reaches the beginning of a track
during audible search, it pauses
there.
6. After the CD changer plays the
last track in the programmed
sequence, it stops automatically.
You can also press
the system or
control to stop the programmed
sequence.
Caution: Do not press
on the system or
remote control more than once.
Doing that clears the programmed
sequence.
Notes:
• If you programmed a non-existent
track (for example, Track 10 when
that CD has only nine tracks), the
CD changer skips the track and
plays the next programmed track.
• The programmed sequence stays
in memory after playback is over.
See "Clearing the Programmed
Sequence" on Page 27 for how to
clear the programmed sequence.
SKIP/
or
or on the
on
STOP
on the remote
STOP
on the