Memory - Packard Bell EasyNote ST Disassembly Manual

55555
2. Lift the cover upwards from the back. There are four tabs holding the cover in place on the
front. Raise the cover until you can remove it from the casing (see
3. Pull the plastic tab on the hard disk drives towards the left to disconnect the drives.
4. Take the drives out of the compartment (see
5. Remove the four screws (Phillips-head) on the metal brackets to separate them from the
hard disk drives.
Note: The drive bays in the compartment are not labelled, so you cannot see which hard disk drive the BIOS
considers the first disk.

Memory

To remove the memory installed, first remove the battery (see
the following steps:
Remove the two screws securing the memory compartment cover.
1.
Lift the cover upwards from the left. There are two tabs holding the cover in place on the
2.
right. Raise the cover until you can remove it from the casing (see
Fig. 3 Disconnecting and removing hard disk drive.
Fig. 4 Removing memory compartment cover.
Packard Bell EasyNote ST Disassembly Manual
Fig.3 on page 5).
Battery on page 4) and then perform
Fig. 2 on page 4).
Fig. 4 on page 5).
5