SATO CLLM Basic 412e Operator's Manual page 32

Section 3: Configuration and Operation
3.3 ACCESSING THE VARIOUS PRINTER MODES (CONT'D)
3.3.1 How to access special Modes and Menus after turning the power ON
Mode/Menu DSW
Normal NA
Advanced NA
Service NA
Counter NA
Motion NA
Test Print NA
Default NA
Settings
Maintenance DSW2-4
Flash DSW2-6
Download
Ready
Boot DSW2-6
Downloader
User DSW2-7
Download
Protocol Code DSW2-7
Select
Hex Dump DSW2-4
Hex Dump NA
(buffer dump)
History Control DSW2-4
Page 3-4
Button(s) to press
Press LINE to toggle ONLINE/OFFLINE
Hold down the LINE button
when turning printer ON
Press the LINE button in Advanced Mode
Press the LINE button in Service Mode
Press the LINE button in Counters Mode
Press the FEED button when turning the
printer ON
Press the LINE and FEED buttons when
turning the printer ON
If DIPSW2-4 is ON, printer goes into
Maintenance Mode. Set DSW2-4 off to
access Factory Mode
Set DSW2-6 ON when turning the printer
ON
Set DSW2-6 ON and hold down the
FEED and LINE buttons when turning the
printer ON
Set DSW2-7 ON and hold down the LINE
button when turning the printer ON
Set DSW2-7 ON and hold down the
FEED and LINE buttons when turning the
printer ON
Set DSW2-4 ON when turning the printer
ON
Turn the printer ON. Send data to it,
press the LINE button to go offline, then
DSW2-4 On. Press Line again.
Set DSW2-4 ON and hold down the LINE
button when turning the printer ON
Comments
ONLINE/OFFLINE STATUS
Each time you pressing the LINE button,
you will rotate through Service Mode,
Counter Mode and Motion Mode
Press LINE again to go to Counters Mode
Press LINE again to go to Motion Mode
Press LINE again to return to Advanced
Mode
Create test prints in this mode
Resets various user settings to factory
default values
Press the LINE button to reach the ALL
CLEAR menu to restore all settings to fac-
tory default values
Readies the printer to receive replacement
firmware code without boot codes
Readies the printer to receive replacement
firmware code with boot codes
Readies the printer to receive user graphics
and fonts, etc
This method initializes the protocol code to
the default value
Generates a hex dump of memory
Generates successive hex dumps of incom-
ing data
Turns the Hysteresis (or History) Control
feature of the print head On/Off
LM Basic 408e/412e Operator's Manual