Dip Switches - Toshiba GN-1010 Operator's Manual

14

DIP Switches

The DIP switches are used to make device settings.
— DIP Switch Default Setting (Factory Setting)
* Default Setting: 1to 3=OFF / 4=ON
— Function of DIP Switch
No. ON
1 INIT
2 -
3 -
4 <INFRA>
The default setting for this device gives priority to the utility software.
•
The GN-1010 operates as a station in default.
•
When the device connection is completed, the GN-1010 can operate as a station.
Launch the utility software, then set the same ESS ID as that of the access point.
When the WEP function is used, the WEP key setting is also required.
OFF
< - > Used to initialize the GN-1010.
1. Turn the power of the GN-1010 ON.
2. LED indicators (POWER, WLNK, WRX) begin to
flash.
3. While they are flashing (approx. 3 seconds), turn
the DIP switch 1 OFF.
Before restarting or turning the power off, wait until
•
the LED indicators (POWER, WLNK, WRX) stop
flashing and the GN-1010 returns to the status prior
to initializing.
- This switch is always at "OFF".
- This switch is not used.
- This switch is always at "ON".
Used in the infrastructure (Wi-Fi mode).
•
Description
GN-1010 User's Manual — Overview