Table of Contents
Advertisement
Configuration
This function sets the basic parameters such as the operating mode as well as the wire-
less parameters.
Configuration Screen
1. Access Point.................... Selects the desired access point.
2. Configuration Tab ............ Configuration menus are organized into each tab.
3. [Password]....................... Changes the password for the selected device.
4. [Read].............................. Reads the configuration for the selected device.
5. [Write] .............................. Writes the currently displayed configuration to the selected
6. [Default] ........................... Restores the factory default setting.
7. [Reboot]........................... Reboots the selected device.
8. [Exit] ................................ Returns to the main menu.
•
•
26
1
2
Password enrty is required for [Password], [Read], [Write], [Reboot] commands.
The factory default setting has no password. In this case, you need not enter any-
thing.
Executing the command "[File] - [Save]" can save the currently displayed configura-
tion on the hard disk and "[File] - [Open]" can load a previously saved file.
3
4
5
• "SNMP" and "Spanning Tree" tabs are not used.
• Up to 6 alphanumerics can be entered and is case-sen-
sitive.
• To change the password, enter the current password
and new one.
• To make the new password effective, the reboot opera-
tion is required.
device.
• To make the configuration effective, the reboot operation
is required.
• To apply the setting, write the configuration to the device
and reboot it.
GN-1010 User's Manual — Functions of the Utility Software
8
6
7
Advertisement
Table of Contents
