To Program Channels Automatically - Toshiba 39L2300U User Manual

You must set up the ANT/CABLE input source before
v
programming channels. See
The automatic channel programming process will erase
v
channels that were previously programmed into the TV's
memory.
To tune the TV to a channel not programmed in the channel
v
memory, you must use the Channel Number buttons on the
remote control.
Programming channels when the ANT/CABLE input is
v
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your Cable
TV service lineup changes significantly.

To program channels automatically:

1 Configure the antenna input source, if you have not already
done so, see
2 Press the MENU button and open the Installation menu.
3 Highlight Channel Tuning, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
4 Highlight Auto Tuning, and then press the ENTER button to
open the Channel Program menu to begin channel
programming.
!
Scanning channels, please wait...
Number of Channels Found -
Scanning Analog Channels
Channel - 9
(Sample Image) Installation menu - Channel selection
"ANT/CABLE IN" on page 51.
Turning
Cable
7
Cancel
Setting up your TV
Auto Tuning
"ANT/CABLE IN" on page 51.
6%
53