Playing Tv Audio Only; Changing Channel Settings; Automatically Scanning For Channels - Toshiba 32L310U20 Manual

Playing TV audio only

You can turn off the picture on your TV and listen to
the program audio only.
1 Press MENU, press
then press ENTER.
2 Highlight Power Management, then press
ENTER.
3 Highlight Audio Only, then press ENTER.
4 Highlight Off or On, then press ENTER.
5 Press EXIT to close the menu.
Notes
• The picture turns off in about five
seconds.
• Press any button to turn on the picture
for about five seconds.
• To exit audio only mode, repeat this
task and select Off.
 or  to highlight Options,
www.tv.toshiba.com

Changing channel settings

This section covers:

• Automatically scanning for channels

• Manually adding channels to the channel list
• Hiding channels
• Setting up the Favorites list
• Tuning to a favorite channel using the FAV button
• Deleting a favorite channel using the FAV button
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press CH
or CH  , your TV goes to the next or previous channel
in the channel list. The channel scan may take several
minutes.
Note
When you scan for channels, your TV
erases any channels already stored in the
channel list.
If a channel is not stored in the channel
list, you can:
• Use the number buttons on the remote
control to enter the channel number.
• Manually add the channel to the
channel list. See
channels to the channel list
1 Make sure that you have set up the
ANT / CABLE IN jack before programming
channels. See Setting up the ANT / CABLE IN jack
on page 25.
2 Press MENU, press
Installation, then press ENTER.
32" 720p 60Hz LED TV
Manually adding
on page 42.
 
or to highlight

41