Cannot Print This Paper Size Select The Other Drawer - Toshiba e-STUDIO2500c Operator's Manual
Basic functions
Hide thumbs
Also See for e-STUDIO2500c:
- Operator's manual (414 pages) ,
- Service manual (402 pages) ,
- Scanning manual (156 pages)
Table of Contents
Advertisement
10 WHEN THIS MESSAGE APPEARS
"Cannot print this paper size Select the other drawer"
When the finisher is installed, 12" x 18" FULL or 320 mm x 460 mm paper cannot exit to the
receiving tray.
When this message appears, delete the print job, change the paper size you set for printing or
specify the finisher as an exit tray, and try again.
Printing can be performed without deleting the print job in the following two ways. However,
some parts of the original image may be missing because the paper size smaller than 12" x 18"
FULL or 320 mm x 460 mm will be used in both cases.
Select a drawer button to be set as a paper source on the touch panel, and press the
[START] button.
Place paper other than 12" x 18" FULL or 320 mm x 460 mm size on the bypass tray and
press the [START] button.
Be sure to specify the paper size.
382
"Cannot print this paper size Select the other drawer"
Advertisement
Table of Contents
