Yamaha YZFR6V(C) Owner's Manual page 92

PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
Tightening torque:
Brake caliper bolt:
35 Nm (3.5 m·kgf, 25 ft·lbf)
5. Install the brake hose holders and
reflectors by installing the bolts
and nuts.
6. Secure the wheel axle by installing
the axle bolt, and then tightening
6
the axle bolt to the specified
torque.
NOTE:
While tightening the axle bolt, hold the
wheel axle with a 19-mm hexagon
wrench to keep it from turning.
Tightening torque:
Axle bolt:
91 Nm (9.1 m·kgf, 66 ft·lbf)
7. Tighten wheel axle pinch bolt B,
and then tighten pinch bolt A to the
specified torque.
1. Front wheel axle pinch bolt A
2. Front wheel axle pinch bolt B
3. Front wheel axle pinch bolt C
4. Front wheel axle pinch bolt D
8. Retighten pinch bolt B to the spec-
ified torque.
Tightening torque:
Wheel axle pinch bolt:
21 Nm (2.1 m·kgf, 15 ft·lbf)
9. Tap the outer side of the right fork
leg with a rubber mallet to align it
with the end of the wheel axle.
10. Tighten wheel axle pinch bolt D,
and then tighten pinch bolt C to the
specified torque.
6-42
11. Retighten pinch bolt D to the spec-
ified torque.
Tightening torque:
Wheel axle pinch bolt:
21 Nm (2.1 m·kgf, 15 ft·lbf)
12. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.