Yamaha YZFR6V(C) Owner's Manual page 25

3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
Odometer, tripmeter, and stopwatch
modes
1. Odometer/tripmeters/fuel reserve tripme-
ter/stopwatch
Push the "SELECT" button to switch
the display between the odometer
mode "ODO", the tripmeter modes
"TRIP A" and "TRIP B" and the stop-
watch mode in the following order:
TRIP A → TRIP B → ODO → Stop-
watch → TRIP A
INSTRUMENT AND CONTROL FUNCTIONS
If the fuel level warning light comes on
(see page 3-2), the odometer display
will automatically change to the fuel re-
serve tripmeter mode "F-TRIP" and
start counting the distance traveled
from that point. In that case, push the
"SELECT" button to switch the display
between the various tripmeter, odome-
ter, and stopwatch modes in the follow-
ing order:
F-TRIP → Stopwatch → TRIP A →
TRIP B → ODO → F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Stopwatch mode
To change the display to the stopwatch
mode, select it by pushing the "SE-
LECT" button. (The stopwatch digits
will start flashing.) Release the "SE-
LECT" button, and then push it again
for a few seconds until the stopwatch
digits stop flashing.
3-7
Standard measurement
1. Push the "RESET" button to start
the stopwatch.
2. Push the "SELECT" button to stop
the stopwatch.
3. Push the "SELECT" button again
to reset the stopwatch.
Split-time measurement
1. Push the "RESET" button to start
the stopwatch.
2. Push the "RESET" button or start
switch " " to measure split-times.
(The colon ":" will start flashing.)
3. Push the "RESET" button or start
switch " " to display the final split-
time or push the "SELECT" button
to stop the stopwatch and display
total elapsed time.
4. Push the "SELECT" button to reset
the stopwatch.
NOTE:
To change the display back to the prior
mode, push the "SELECT" button for a
few seconds.
3