Set System Date And Time; Read Software And Firmware Revision Number; Ending Communications - Valcom V-2928 User Manual

Receive Data from V-2924A
From the main menu, select Receive Data from V-2924. This will take place automatically. If you are not
allowed to select Receive Data from V-2924, close the currently open file and try again. Messages will be
displayed stating Receiving Data, Receive Data Completed Successfully. Click on OK.

Set System Date and Time

Set System Date/Time by clicking on the Date/Time pull-down menu. Up/Down arrows are used to move date
and time to the desired setting. Press Update to set the new Date/Time or Cancel to leave unchanged. The
Automatic DST Adjustment can be enabled or disabled here. The DST correction is based on the pre-2007
rules (first Sunday of April, last Sun of October) therefore it is recommended to not enable the Automatic DST
Adjustment.
Read Software and Firmware Revision Numbers
This feature is accessed through the Help menu. Select Help, then About. This option provides information
for all processors.
Reminder: The PC must be connected to the system to access this information.

Ending Communications

Direct Connect:
Modem Connect:
No action required, just unplug cable.
From the pulldown menu, select File, Modem, Modem Release.
17