Using Stores, Recall And Send Features; Introduction; Storing And Clearing Readings - UNI-T UT804 Operating Manual

Introduction

Chapter 4 shows you how to use stores, recall and
communication features available on the Meter
Store and Clearing Readings
To store readings, proceed as follows:
l
Press STORE once, "STORE" and "No.xxxx"
appears to confirm the operation and the upper right
secondary display shows the current measurement
reading. Press to toggle between clearing the
stored readings and start from the first readings or
start from the last stored reading. Lower right
secondary display shows the original number of
records.
l
Press STORE the second time, "STORE" and "s"
appears. The upper right secondary display shows
the storing time interval in second, it is preset to
zero which means it will not auto update reading.
To change the interval in second by pressing + or
46
Model UT804: OPERATING MANUAL
Using Store, Recall & Send Features
- button. The interval can be as high as 255 seconds
or as low as 0 second. Press and hold + or - to
access the quick setting.
l
Press STORE the third time, "STORE" and "No.
9999" appears. The upper right secondary display
shows the index number increase one. The lower
right secondary display shows the value of the
corresponding index number, the primary display
shows the current measurement reading.
l
If there is no set time to store the reading, each
press of STORE to store one reading. An index
number increase one.
l
The maximum number of stored reading is 9999.
When the stored readings memory is full, the Meter
will stop storing data.
l
To exit and stored the reading, press EXIT.
l
To exit without storing the reading, turn the Meter
off directly.
l
Automatic power off feature will be disabled after
entering this mode.
Chapter 4