Firewall Software Configuration; Replacing Damaged Hard Drives; Hard Drive Damage; Replacing A Hard Drive - Thecus N5200B, N5200BR User Manual

b. You should see the login page of N5200.

Firewall Software Configuration

If you are using a software firewall (i.e. Norton Internet Security) and are having
trouble connecting to the N5200, you can try the following steps:
1. Double click the NIS icon on system tray, and then configure the
Personal Firewall.
2. On the Programs page, find the SetupWizard.exe and change its
permission to "Permit All". If it's not in the program list, use the Add or
Program Scan buttons to find it.
3. On the Networking page, manually add N5200 IP address (i.e.
192.168.1.100) to the Trusted list.

Replacing Damaged Hard Drives

If you are using RAID 1, RAID 5, RAID 6, or RAID 10, you can easily replace a
damaged hard drive in the Thecus N5200 while keeping your data secure with the
system's automatic data recovery.

Hard Drive Damage

When a hard drive is damaged and data in the RAID volume, the system LCD will
display warning message also the system beeps.

Replacing a Hard Drive

To replace a hard disk drive in the N5200:
1. Remove the tray with the damaged hard disk.
2. Unscrew the damaged hard disk and remove it from the tray.
3. Slide a new hard disk into the tray and fasten the screws.
4. Insert the hard disk tray back into the N5200 until it snaps into place. You
can also lock it with a key if desired.
5. The LED blinks green when the HDD is accessed.

RAID Auto-Rebuild

When using RAID 1, 5, 6, or 10 on the N5200, you can use the auto-rebuild
function when an error is detected.
1. When a hard disk fails the system beeps and/or an email notification is
sent to specified receivers.
2. Check the LCD to see which disk has failed.
3. Follow the steps mentioned above to replace the failed hard disk.
4. The system automatically recognizes the new hard disk and starts the
auto-rebuild sequence to resume its status before the hard disk crash.
72