Chapter 8: Troubleshooting; Forgot My Password; Forgot My Network Ip Address; Resetting Nas Ip Address And Admin Password - Thecus N5200B, N5200BR User Manual

Chapter 8: Troubleshooting

Forgot My Password

If you forget your password, you can reset the unit to use the default password.
To do this, press the reset button on the front panel after system is booted, and
N5200 will be reset. WAN IP address will become 192.168.1.100 and admin
password will be admin.

Forgot My Network IP Address

If you forget your network IP address and have no physical access to the system,
you can find out the IP address by either looking directly onto the N5200's LCD
panel, or by using the setup wizard to retrieve the IP of your N5200.
1. Start the Setup Wizard, and it will automatically detect all Thecus IP
storage products on your network.
2. You should be able to find the IP address of the N5200 which you have
forgotten in the Device Discovery screen.

Resetting NAS IP Address and Admin Password

In case you changed the N5200 IP address and then forgot it, or forgot the
administration password, follow the steps below to reset to default settings:
1. Power on the N5200 till system ready and press the Reset button while
buzzer with long beeping approximately 3-5 seconds. (The reset button is
right below power button)
2. This resets the N5200 to its default IP address and password settings.
Default IP: 192.168.1.100 for WAN and 192.168.2.100 for LAN
Default admin password: admin
Jumbo Frame support: disabled
HTTP Port: 80, HTTPs:443

Can't Map a Network Drive in Windows XP

You may have problems mapping a network drive under the following conditions:
1. The network folder is currently mapped using a different user name and
password. To connect using a different user name and password, first
disconnect any existing mappings to this network share.
2. The mapped network drive could not be created because the following
error has occurred: Multiple connections to a server or shared
resource by the same user, using more than one user name, are
not allowed. Disconnect all previous connections to the server or shared
resource and try again.
To check out existing network connections, type net use under the DOS prompt.
You may refer the URL below for more network mapping information.
http://esupport.thecus.com/support/index.php?_m=downloads&_a=viewdownload&downloaditemid=5
7&nav=0
73