Soft Power Connector; Speaker Connector Installation; Hardware Reset Switch Connector Installation; Wavetable Upgrade - TYAN Thunder 100 S1836 User Manual

Soft Power Connector

The Soft Power Connector is located on pins 1 and 2 of jumper block
J10. The Thunder 100 uses the PIIX4e chip for power management,
including turning on and off the system. If the Power Button Function
option in the Power Mangement Menu is set to On/Off (which is the
default), pressing the power button once, after the BIOS has booted up,
will turn the system on and off. If the Power Button Function option is
set to Suspend, pressing the power button once will wake the system or
send it in to Suspend mode. In this case, you cannot turn the system off
unless you shut down through the Windows operating system or you
hold the power button down for four seconds.

Speaker Connector Installation

The Thunder 100 provides a 4-pin header to connect the speaker. The
speaker is connected to pins 24-27 of jumper block J10.
Hardware Reset Switch Connector
Installation
The Reset switch on your case's display panel provides you with the
Hardware Reset function, which is the same as power on/off. The
system will do a cold start after the Reset button is pushed. The Reset
switch is a 2-pin connector and should be installed on pins 22 and 23 of
jumper block J10.

Wavetable Upgrade

The Creative Labs Vibra 16XV chip can be upgraded to produce
wavetables using a peripheral card. This card will have a cable which
needs to be connected to JP17. Contact a Creative Labs distributor or
dealer for availability of their peripheral card.
S1836 Thunder 100
33