Battery Removal - Triumph America Handbook

Maintenance and Adjustment

Battery Removal

4
T908045aUSA
1. Airbox finisher
2. Airbox finisher fixing
3. Airbox cover
4. Airbox cover fixings
5. Stud and grommet location
3
T908045bUSA
1. Battery cover
2. Battery cover strap
3. Battery cover strap fixing
• Release the screw securing the
airbox finisher to the airbox cover.
Remove the finisher.
• Release the screws securing the
airbox cover to the airbox.
80
1
3
2
5
1
2
• Ease the cover outwards from the
motorcycle releasing a stud, located
at the rear of the cover, from its
grommet.
• Remove the fixing from the battery
cover strap.
• Detach the strap from its lower
hinge and remove the battery cover.
• Disconnect
negative (black) lead first.
Warning
Ensure that the battery terminals do not
touch any part of the motorcycle as this
may cause a short circuit or spark which
would ignite battery gases causing a risk of
personal injury and damage to the
motorcycle.
• Tilt the battery outward from the top
to remove it from the battery tray.
Note:
• The Engine Control Module (ECM)
is located at the rear of the battery
tray and
motorcycle by the battery. Ensure
the ECM is not disturbed during
the battery removal or installation
process.
the battery leads,
is secured to the