Vauxhall Corsa & Combo Owner's Manual page 191

7. Screw in wheel bolts and tighten slig htly,
inserting the wheel bolt wrench 3 as far
as possible.
8. Lower vehicle.
9. Tighten wheel bolts crossw ise, putting on
wheel bolt wrench 3 as fa r as possible.
10. Before refitting the w heel trim, clean the
wheel around the retaining clips. Valv e
sym bol 3 on back of wheel trim must
point towards va lv e on wheel.
Align and engage hub cap or wheel
trim 3 and wheel bolt c aps 3.
Alloy wheels 3 : Put hub cap on and
engage, inserting pin on rear of hub
ca p into relevant hole in wheel.
Alloy wheels with anti-theft lock 3: Put
hub ca p on. Insert and tighten anti-
theft lock 3.
11. Close the jacking point flap on the
underside of the vehicle 3. Stow the
repla ced w heel – see page 182. Put
away the tools and warning triangle –
see pages 180, 184.
12. Check the pressure of the new ly fitted
wheel. Adjust as necessary.
13. Have the tightening torque of the wheel
bolts on the new wheel checked on the
vehicle using a torque wrench as soon
as possib le and , if necessary, corrected.
Tightening torque – see page 249.
14. Replace the faulty tyre on the wheel
that was rem oved.
15. Replace the tem pora ry spare wheel 3
with a full specification wheel without
delay.
189