Bosch DAF220 Original Instructions Manual page 14

daf220_bu_2609140572_003.fm Seite 15 Montag, 8. September 2008 2:22 14
– Set this value as the spring angle
by pressing the COMPOUND
MTR button.
– The entry is confirmed by the
appearance of "SPR" in the dis-
play.
OR
B) Recall A Spring Angle Stored
in "HOLD" (Recommended for
easy repeated use.)
See "HOLD (Memory)" section
– Press the RECALL/HOLD for less
than 1 second to recall the
stored angle.
– Set this value as the spring angle
by pressing the COMPOUND
MTR button.
– The entry is confirmed by the ap-
pearance of "SPR" in the display.
– The main display reverts to
showing the angle to which the
tool is opened.
* To determine the spring angle; see
"How to Determine The Spring Angle of
A Crown Molding" section below
Bosch Power Tools 2 609 140 572 | (8.9.08)
| 15