Advertisement
SYMPTOM
Fryer will not heat
Burners won't light, or "pop" when igniting
Lift cradle will not lower
Lift cradle will not raise
POSSIBLE CAUSE
Unit disconnected from electric power
Menu temp not programmed or set too
low
Hi-Limit thermostat (item 9) tripped
Fryer in CLEAN mode
(Display reads BOIL)
Fryer in STANDBY mode
Drain not fully closed (filter wand option)
Internal damage
GAS SHUT-OFF VALVE(S) not fully ON
Gas pressure not correct
Internal damage or internal component
mis-adjusted
Menu key not programmed for time, or
programmed to 00:00
Internal damage or mis-adjustment
PAUSE pressed
Lift cradle not properly assembled to lift
rod
Internal damage or mis-adjustment
CONTINUED ON PAGE 30
29
TROUBLESHOOTING
SUGGESTED REMEDY
Reconnect to power
Check/reset circuit breaker
Press TEMP key to check current
temperature. Program menu key for
desired temperature as required
Allow unit to cool, reset hi-limit
See page 3
Press power switch OFF, wait 10
seconds, press power switch to FRYER
Press STANDBY key for three seconds
(beep will sound). Press and release
MENU key to resume cooking.
Be sure drain handle is fully closed
(drain safety switch made).
Contact your Authorized Wells Service
Agency for repairs
Verify that gas shut-off valves are in full
open position
Verify that gas pressure regulators are
are adjusted to the recommended
pressure.
MUST BE PERFORMED BY A
QUALIFIED TECHNICIAN.
Contact your Authorized Wells Service
Agency for repairs
Program menu key for desired time.
Be sure to press BASKET + DOWN to
lower basket.
Contact your Authorized Wells Service
Agency for repairs
Be sure to press BASKET + DOWN to
lower basket. Press PAUSE when
basket is down to resume
Properly assemble cradle pivot to lift rod
Contact your Authorized Wells Service
Agency for repairs
NOTE: There are no user serviceable
components in the fryer. In all cases of
damage or malfunction, contact your
Authorized Wells Service Agency for
repairs.
Advertisement
