Switching On/Off; Adjusting The Volume; Setting The Power-On Volume - Blaupunkt Kingston MP47 Operating Instructions Manual

Switching on/off

Switching on/off
There are various ways of switching the de-
vice on/off:
Switching on/off with the On/Off button
u
For switch-on, press the On/Off but-
ton 3.
The device switches on.
u
To switch off the device, press and hold
down the On/Off button 3 for longer
than two seconds.
The device switches off.
Switching on/off using the vehicle
ignition
The device will switch on/off simultane-
ously with the ignition if the device is cor-
rectly connected to the vehicle's ignition as
shown in the installation instructions and
you did not switch the device off by press-
ing the On/Off button 3.
Switching the device off using the
detachable control panel
u
Detach the control panel.
The devices switches off after the time set
in the "OFF TIMER" menu.
Note:
To protect the vehicle battery, the de-
vice will switch off automatically after
one hour if the ignition is off.
48

Adjusting the volume

You can adjust the volume in increments
from 0 (off) to 66 (maximum).
To increase the volume,
u turn the volume control 4 clockwise.
To decrease the volume,
u turn the volume control 4 counter-
clockwise.

Setting the power-on volume

You can set the power-on volume.
u Press the MENU/OK button ;.
u
Press the or
edly until "ON VOLUME" appears on the
display.
u button 9 to adjust a spe-
Press the
cifi c power-on volume, or the
9 to select the "LAST VOL" setting.
u
Set a specifi c power-on volume with
button <.
the or
To help you adjust the setting more easily,
the device will increase or decrease the vol-
ume as you make your changes.
If you enable "LAST VOL", the volume which
was set the last time you switched off the
device is re-enabled.
Note:
To protect your hearing, the power-on
volume is limited to the value "38" for
the setting "LAST VOL". If the volume
was higher before switch-off, the value
is automatically set to "38" at switch-
on. This prevents an unintentionally
and unexpectedly high volume when
switching on the device.
Volume
button < repeat-
button