Bissell CLEANVIEW DEEP CLEAN 42U7 SERIES User Manual page 14

O
perations
Cleaning with attachments continued
8. Remove and rinse tools in clean, running
water. Dry and replace in the tool caddy.
9. It is recommended that you suction clean
water from a bowl to rinse out the hose.
10. Before replacing lift end of hose and
stretch out to ensure all water is cleared
from hose.
11. Coil flex hose around the tool caddy.
12. Empty 2-in-1 water tank and rinse out,
following the instructions on pages 11
through 12.
13. Return ReadyTools dial to floor setting.
Cleaning with Deep Reach™ Tool
(select models only)
1. Set tool on soiled surfaces and press the
spray trigger to spray solution onto the
soiled area to be cleaned.
2. Slowly move the tool back and forth over
the soiled surface, keeping the tool in con-
tact with the carpet.
Release spray trigger and move tool
slowly over the soiled area to suction up
water and dirt.
4. Continue to clean the area, working in
small sections, until no more dirt can be
removed.
14
w w w . b i s s e l l . c o m
10.
1.
3.