Bissell CLEANVIEW DEEP CLEAN 42U7 SERIES User Manual page 11

O
perations
Carpet cleaning continued
6. Plug into a proper outlet and turn the power
and heater switches to the ON ( I ) posi-
tion. Allow 1 minute for the built-in heater to
warm-up before cleaning. The CleanView
Deep Clean will be fully warmed and will
provide optimal performance after a minute
of continuous heated cleaning.
7. Cleaning Strokes. While pressing the trig-
ger, make one slow forward wet pass and
another one back. Caution: Do not
overwet. Take care not to run over loose
objects or edges of area rugs. Stalling
brush may result in premature belt failure.
Note: Your machine is equipped
with a circuit breaker that will
automatically shut off the brush if
a large or loose object is caught
in the brush roll. If that happens,
be sure to unplug your machine,
remove the foreign object, and
then plug the machine back in to
reset the circuit breaker.
Release the trigger and make one slow
forward and backward pass over the
same area to remove any residual
dirty water and aid in drying. Repeat
cleaning passes until solution being
pulled up appears clean. Continue
passes without pressing the trigger until
you can't see any more water being
pulled up.
8. Remove the tank from the base of the
machine by lifting up on the tank carry
handle. Carry like a bucket to a utility sink
or outside where you will dispose of the
dirty water.
8a. Unlatch the top of the tank from the
bottom by lifting up on the tank latch
located on the back of the tank.
8b. Remove the top of the tank by lifting up on
the handle.
Note how the lip on the top tank
separates from the groove in the
bottom tank. This placement is
important when putting the tank
back together.
w w w . b i s s e l l . c o m
6.
®
Power Switch
WARNING:
To reduce the risk of due to internal
component damage, use only
BISSELL cleaning formulas intended
for use with the deep cleaner.
8.
8b.
Heater Switch
8a.
11