This Quick Start Guide Do not use the myGuard 7202(G) in high humidity or high temperatures. Do not use the same power source for the myGuard 7202(G) as other equipment. Do not open or repair the case yourself. If the myGuard...
Quick Start Guide The Front LEDs myGuard 7202 myGuard 7202G Meaning PPP : Lit steady when there is a PPPoA / PPPoE connection. ADSL: Lit when successfully connected to an ADSL DSLAM (“linesync”). Lit when connected to an Ethernet device.
7202(G) ADSL2+ Modem/ Router The Rear Ports myGuard 7202 myGuard 7202G Port Meaning Power Switch Power ON/OFF switch Connect the supplied power adapter to this jack. 1. After the device is powered on, press it to perform Failure recover for a dead routers: Simply hold the Emergency/Failure Recovery Button”...
Page 6
Quick Start Guide Connecting myGuard 7202 1. Connect the Router to a LAN (Local Area Network) and the ADSL/telephone (LINE) network. 2. Power on the device. 3. Make sure the PWR and SYS LEDs are lit steadily and that the relevant LAN LED is lit.
Page 7
7202(G) ADSL2+ Modem/ Router Connecting myGuard 7202G 1. Connect the Router to a LAN (Local Area Network) and the ADSL/telephone (LINE) network. 2. Power on the device. 3. Make sure the PWR, SYS, and WLAN LEDs are lit steadily and that the relevant LAN LED is...
Quick Start Guide Configuring PC in Windows XP 1. Go to Start / Control Panel (in Classic View). In the Control Panel, double-click on Network Connections 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window, click Properties. 4.
7202(G) ADSL2+ Modem/ Router Configuring PC in Windows 2000 Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and Dial-up Connections. 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window click Properties.
Quick Start Guide Configuring PC in Windows 98/Me 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Configuration tab. 2. Select TCP/IP -> NE2000 Compatible, or the name of your Network Interface Card (NIC) in your PC.
Page 11
7202(G) ADSL2+ Modem/ Router Configuring PC in Windows NT4.0 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Protocols tab. 2. Select TCP/IP Protocol and click Properties. 3. Select the Obtain an IP address from a...
Page 12
Quick Start Guide Configuring Your ADSL Firewall Router To configure this device, you must have IE 5.0 / Netscape 4.5 or above installed Open the web browser and type http://192.168.1.254 in the browser’s address box. This number is the default IP address for this router.
Page 13
7202(G) ADSL2+ Modem/ Router Verifying Your Local Network Connection with the Device To see if this ADSL Router is visible on the local network, go to Start / Run. In the Run dialog box, type “ping 192.168.1.254” then press OK.
Most problems can be solved by referring to the Troubleshooting section in the User’s Manual. If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer where you purchased this product. Contact Billion WORLDWIDE http://www.billion.com Mac OS is a registered Trademark of Apple Computer, Inc.
Need help?
Do you have a question about the myGuard 7202 and is the answer not in the manual?
Questions and answers