Baby Lock Pro-Stitcher BLPS2 Instruction And Reference Manual page 75

Problem/ Symptom
Error Messages
Motor Error with lightning bolt icon in the top
right-hand corner (may occur with various types
of Motor Error messages on the screen).
Buffer Underflow
System Restore or System Repair message
on boot-up.
Corrective Measure
This will occur with various types of motor errors.
Generally they mean that the Pro-Stitcher cannot
communicate with the motors. Check that the
carriage is plugged in and that the serial cables
are connected properly into the box behind the
Pro-Stitcher computer. If everything is connected
properly and power is on, press the lightning bolt
button to attempt to reestablish communication
with the motors. The icon will turn to either a red
or green motor button once communications are
re-established.
If a message with the words Buffer Underflow
appears while stitching, it is an indication that data
is not getting to the motors quickly enough. This
may be due to something in the computer tying up
the CPU. Although it may be possible to resume
quilting by simply pressing red X box to close
the error message and then pressing the Motor
Error lightning bolt button at the top right-hand
corner of the screen, it is best to cancel the current
design stitch-out, save the pattern, and re-boot the
computer. Use the New Start Point function
if necessary to resume from where stitching was
left off.
If a message appears on boot-up (black screen, white
text) that asks whether to run System Restore or
Start Windows Normally, select Start Windows
Normally by using the keyboard. Plug the keyboard
into the open USB port using the USB extension
cable and press Start Normally and the system
should resume as normal. The computer will default
to the System Restore screen (more of a typical
Windows blue/white screen) if you do not select the
Start Normally option in time. If this occurs, use
the power switch to reboot the computer and try
again.
Troubleshooting 9.5