Baby Lock Pro-Stitcher BLPS2 Instruction And Reference Manual page 10

4. Make adjustments to the placement of the blue
rack as necessary to align the blue flexirack with
the front white gear on the Pro-Stitcher carriage
(Figure 3.4).
5. If alignment using the wooden block is accurate,
continue using the wooden block as a guide to
mount the remainder of the blue rack to the table
top. Otherwise, use the carriage as a guide and align
the blue rack with the white gear along the length
of the table, removing the pink protective layer and
pressing downward on the blue rack while moving
down the entire length of the table top.
6. Trim the flexirack to length using a knife or wire
cutters if necessary (the blue flexirack does not
necessarily need to extend the full width of the table
and can actually be a couple of inches shorter on
either end, if desired).
7. At the ends of the blue flexirack, use the four
small metal clamps (Page 3.3, B) to hold the ends
firmly in place (Figure 3.5). The clamps have
a hole through the center and a lip on one end.
The lip should be on the side opposite the blue
flexirack. Drill pilot holes using the 3/32" drill
bit and then attach the clamps as shown on either
end of the blue flexirack using a Phillips screw-
driver.
Note: Do not use the larger drill bit included in the
emergency repair kit...this is the wrong size for the
X-rack clamps! As an alternative, choose to use one
clamp at each end using the lip of the clamp to slide
over the last gear of the flexirack (Figure 3.6).
Figure 3.4
Lip
Figure 3.5
Lip
Figure 3.6
Installation Instructions 3.5