Baby Lock Diana BL480A Getting To Know Manual page 6

Threading the Upper Looper (Green)
Open the front cover and thread the upper
looper as indicated in steps 1 through 9.
CAUTION: Be sure to turn off power switch
• Raise Presser foot to release tension discs.
• Thread the upper area of the machine following
the green color-coded thread guides.
Pass thread from back to the front through the
1
thread guide.
2 Thread the top cover thread guide by pulling
the thread towards the left until it slips under
guide. Then pull thread along the right side of
pretension disc as illustrated.
3 While holding thread with fingers, pass it
between the tension discs and pull thread
down to make certain it is properly located in
between the tension discs.
Place the thread from right to left into
4
thread guide.
5 Place the thread from left to right and
position thread behind finger on thread
guide.
Manual Threading
4
1
2
3
4
9
5
8
7
6
1