Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual page 8

Y-Rack Installation
1.
Carefully lay the quilting machine on its side
(Figure 6). Underneath the base plates, near the
wheels on the side of the machine facing up (the
side with the thread tensioner and guides) there will
be either two screws or two holes. If the screws are
there, use a large slotted (fl at) screwdriver to remove
the screws (Figure 5).
2.
Attach the Y-Rack as shown in Figure 6. The blue
fl exirack should be toward the middle of the machine
while the bolt holes should be toward the outside.
Use the screws that were removed from the front and
rear base plates (or use the two smallest screws in
the Base Plate Repair Kit (Page 3, D) if your machine
had no screws here) to mount the Y-Rack to the bot-
tom of the front and rear base plates. Be careful not
to over-tighten the screws as the base plate holes will
strip easily. In case of accidentally cross-threading or
stripping one of the base plate holes, an emergency
repair kit (Page 3, D) has been provided.
3.
If the screws in the base plates do not have slot-
ted heads and a nut driver cannot be fi tted over the
screw head, please use one of the provided slotted
screws as a replacement (Page 3, D) and use a slotted
screwdriver to tighten the screws in place.
Page 6
Figure 5
Y-Rack
Y-Encoder
Figure 6