Table of Contents
Advertisement
User Manual
The basic settings for the wireless network are set on this page:
SSID (Service Set Identifier) Enter a value of up to 32 characters. The same SSID
must be assigned to all wireless devices in your network. The default SSID is
yournetworkname, but it is recommended strongly that you change your
networks name (SSID) to a different value. This value is case-sensitive.
Region Select your region from the pull-down list. This field specifies the region
where the wireless function of the router can be used. It may be illegal to use the
wireless function of the router in a region other than one of those specified in this
field. If your country or region is not listed, please contact your local government
agency for assistance. The default region is United States. When you select your
local region from the pull-down list, Click Save, then the Note Dialog appears.
Click OK.
Note: Limited by local law regulations, version for North America does not have
region selection option.
Channel This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice interference problems
with another nearby access point.
Mode Select the desired wireless mode. The options are:
54Mbps (802.11g) Both 802.11g and 802.11b wireless stations can
connect to the router.
11Mbps (802.11b) Only 802.11b wireless stations can connect to the
router.
Note: The default is 54Mbps (802.11g), which allows both 802.11g and 802.11b
wireless stations to connect to the router.
Enable Wireless Router Radio The wireless radio of this Router can be enabled or
disabled to allow wireless stations access. If enabled, wireless stations will be
able to access the router, otherwise, wireless stations will not be able to access.
Page 46 of 102
Advertisement
Table of Contents
