Connecting the Router Connecting the Router Connecting the Router Connecting the Router Before installing the router, you should have connected your PC to the Internet through your broadband service successfully. If there are any problems, please contact with your ISP. After that, please install the router according to the following steps.
h. When all of the devices boot up completely, make sure that the router's LEDs light as follows: • Power LED: Light up • System LED: Flash • Link/Act LEDs (WAN&LAN): Light up • WLAN LED: Flash Login to the Router Login to the Router Login to the Router Login to the Router...
Page 5
Connecting Connecting to to to to the Internet Connecting Connecting the Internet the Internet the Internet a. After successfully login, you can configure the router using the web browser. Please click the Quick Setup link on the left of the main menu and the Quick Setup screen will appear.
After you complete the above, click Next Next, the Wireless settings screen will appear Next Next as the following: d. At the end of the Quick Setup Quick Setup, click the Finish Finish button to exit this Quick Setup Quick Setup. The Quick Setup Quick Setup Finish...
Page 7
2) You can establish a wireless connection by using either Push WPS Button Push WPS Button Push WPS Button Push WPS Button method or PIN PIN method. It is recommended that you choose the simplest method that your AP device supports. 3) Below is an example of the wireless adapter software.
Page 8
2) 2) 2) 2) Enter the PIN Enter the PIN code of the router into code of the router into the wireless adapter the wireless adapter..Enter the PIN Enter the PIN code of the router into code of the router into the wireless adapter the wireless adapter...
Page 9
Note Note Note Note: 1) For the router, please keep the default WPS Status as Enabled Enabled all the time. Enabled Enabled 2) The status LED on the Router will light green all the time if the device has been successfully added to the network.