Remote Control Operation; Remote Effectiveness - Friedrich ES15M33 Installation And Operating Manual

Remote Control Operation

Remote Control – Refer to Figures 11 and 12 during operation description.
Getting Started – Install two (2) AAA batteries in the battery compartment
located on the back of the unit.
Operation – The remote control should be within 25 feet of the air
conditioner for operation (Refer to Figure 10 for effectiveness). Press the
button to turn the remote on. The remote will automatically power off
after 15 seconds if the buttons are not being pressed. The remote must
be on to control the unit.
POWER Button – Turns remote and unit on and off.
SYSTEM Button – Allows the user to sequentially select,
HEAT , and FAN ONLY operation. When the button is pressed, the
i d p s a l i y d n c i t a s e w i h h c m o e d h
Note that when the heating function is not available, the system will
automatically skip the HEAT and AUTO modes.
FAN MODE Button – Selects between automatic (
operation. In the AUTO mode, the fan only turns on and off when the
compressor operates or the heat function is enabled.
NOTE: AUTO is not available in the FAN ONLY Mode, the display
indicates . In the
determined by your selection on the
Figure 10
SIDE VIEW
s a e b n e e s e l t c d e v a i a i d p s y a l m
) or
mode, fan speed is
button.
7.5ft
30°
45°
60°
60°
45°
30°
8ft
FAN SPEED Button – Used to sequentially select new fan speed, plus
AUTO operation. When the
temporarily displayed in the display window, plus a fan speed icon (triangle)
changes to indicate the new speed level. Fan speed automatically varies
depending on the set temperature on the control panel and the actual
room temperature. Let me explain. Say for example you're working in
your garage and you need to open the big door for several minutes. Since
there is a big difference between your set temperature and the actual room
temperature the system fan speed increases to MAX. It remains at this
speed until the room temperature matches the set temperature.
SCHEDULE Button – The
off. Pressing the
off. Only the schedule icon
Cool ,
UP and DOWN Arrows – Pressing either the
e s s g a . e button changes the desired room temperature. The factory preset lower
and upper limits are 60° F (16° C) and 99° F (37° C). These buttons are
also used to navigate between function options when using the User Menu
or Maintenance Mode.

Remote Effectiveness

Hand Held Remote – Has an operating range of up to 25 ft. The infrared
remote control signal must have a clear path to transmit the command to
the air conditioning unit. The remote signal has some ability to "bounce"
off of walls and furniture similar to a television remote control. The diagram
below shows the typical operating range of the control in a standard room
with 8 ft high ceilings.
25ft
25ft
25ft
25ft
25ft
button is pressed, the fan speed is
FA N
SPEED
button turns the schedule function on and
SCHEDULE
button a second time turns the schedule function
SCHEDULE
will be displayed.
TOP VIEW
4ft 60°
60°
45°
45°
8ft
30°
30°
25ft
25ft
(UP) or (DOWN)
6ft
16ft
25ft
FRR046
15