To install a PC card:
1.
Insert the PC card into slot 1 or slot 2.
2.
Select Appliance Settings-Pluggable Devices. The Pluggable Devices content area is
displayed. If Pluggable Devices Detection is enabled, the inserted PC card's Device Name,
Device Type, Card and Device Info are shown.
NOTE: A hard disk PC card is automatically mounted and configured once it is inserted.
To configure a PC card:
1.
Select Application Settings - Pluggable Devices. The Pluggable Devices content area is
displayed and all mounted PC cards are shown.
2.
Click on the PC card device name. The page for the PC card device type is displayed.
3.
Configure the PC card parameters.
NOTE: PC card storage devices are automatically configured.
To eject a PC card:
CAUTION: Always use the Web Manager to eject a PC card. Any other method may cause a kernel panic.
1.
Select Application Settings - Pluggable Devices. The Pluggable Devices content area is
displayed and all mounted PC cards are shown.
2.
Select the checkbox next to the PC card device name you want to eject, then click Eject All.
3.
Remove the card from the slot.
Chapter 2: Installation
23