Table of Contents
Advertisement
Address Log
Board Installation
Installation
Select a unique I/O base address from the list in Figure 2-2 for the ISA
host controller board. Assign the I/O base address by setting S1 (DIP
switch shown in Figure 2-1) to the selected address.
If you select an address that is invalid, simply shutdown your system
and select another address. It is not necessary to reinstall the software
driver after changing the I/O addresses.
You may need to refer to the I/O base address assigned to the board(s)
when installing the driver. Write the selected address for each board
installed in your system in the following table.
1._________ 2._________ 3._________ 4._________
5._________ 6._________ 7._________ 8._________
Use the following procedure to install your Megaport SS Board.
Alternatively, you may follow the installation instructions presented in
your host system documentation.
1.
Set the host computer system power switch to OFF and
disconnect the power cord.
2.
Locate a free expansion slot.
3.
Insert and secure the board firmly into the expansion slot.
4.
Replace the power cord and turn the host computer
system ON.
I/O Base Address Log
2-3
Advertisement
Table of Contents
