2.3.2. ADAPTER FOR A.R.M.S. MOUNTS
The PS-40 can be installed on MIL-STD-1913 rail by means of using
an A.R.M.S. #10 or A.R.M.S. #19 ACOG mounts. Optional adapter
is used to attach the sight to the said mounts.
A. Loosen and remove two screws (M4x8) that secure the quick
release mount to the sight body. Remove the mount.
B. Loosen and remove two screws (M5x8) installed in the adapter.
C. Put the adapter on the sight body. The adapter should not
protrude out beyond the back of the sight body. Apply a small
amount of thread locker on threads, install two screws M4x8 and
tighten it.
D. Place the A.R.M.S. mount onto the sight. Apply a small amount
of thread locker on threads, install two screws M5x8 and tighten.
M4x8 screw
M5x8 screw
Figure 2-8. Assembling PS-40 with A.R.M.S. Mount
2.3.3. REMOTE CONTROL
Remote control is designed to operate the PS-40 in short-time ac-
tivation mode.
Attach the remote control to the PS-40 and use it as follows:
A. Remove the cap from the remote switch connector.
2-12
using Adapter
Adapter
A.R.M.S.#19 Mount