Do you have a question about the Aries MK390 "Paladin" and is the answer not in the manual?
Questions and answers
Andrew Lee
May 30, 2025
Night time in darkness not very bright. The power light is green. The top scope battery is dead. Is that the problem?
2 comments:
Mr. Anderson
May 30, 2025
Yes, a dead battery in the top scope of the ATN MK390 "Paladin" can cause the night vision to not be very bright in darkness, as the device relies on battery power to operate, including powering the infrared illuminator which enhances brightness in low-light conditions.
This answer is automatically generated
Andrew
May 30, 2025
@Andrew Lee How do I focus the the crosshairs on the nigh scope? Do I need to sight in during the night?
Page 1
Aries mk390 “paladin” ArIeS 390 “PALADIN” USer’S GUIDe (rev. 3, SePtemBer 2010) u s e r ` s g u i d e important export restrictions ! Commodities, pro-ducts, technologies and services contained in this manual are subject to one or more of the export control laws and regulations of the U.S.
Page 3
• Dimensions: 275 mm x 108 mm x 85 mm /10.8” x 4.1” x 3.3” • Weight: 1.45 kg /3.2 lbs * ATN reserves the right to change the above specifications at any time without notice prepArATion For operATion Before getting started make sure to follow these steps: •...
NOTE: Receptor attachment screws may need to be tightened after continuous shooting. mounTing sysTem the AtN Night vision riflescopes mounting System allows to change the position of the rif- lescope flexibly on the weapon in relation to a shooter in combination with the fixed positions already available on the weaver rail.
Page 5
Focusing to focus your riflescope you will need to adjust the ±5 Diopter diopter first thing. Simply turn the diopter clockwise until it stops. then, while looking through the diopter at a subject, slowly turn the diopter back counter clockwise until the grain in the image is sharp. NOTE: We suggest that you focus the diopter during daylight with the filter on.
Adjust the potentiometer, to reduce brightness. Q: A pattern of dark thin lines which look like chicken wire. s: turn on illuminator, if purchased. If illuminator doesn’t brighten image, replace batteries. If problem persists, contact AtN for service instructions.
Page 7
AtN, at its option, will ei- ther repair or replace the product, and such action on the part of AtN shall be the full extent of AtN’s li- ability, and the Customer’s sole and exclusive remedy. this warranty does not cover a product (a) used in other than its normal and customary manner;...
Need help?
Do you have a question about the Aries MK390 "Paladin" and is the answer not in the manual?
Questions and answers
Night time in darkness not very bright. The power light is green. The top scope battery is dead. Is that the problem?
Yes, a dead battery in the top scope of the ATN MK390 "Paladin" can cause the night vision to not be very bright in darkness, as the device relies on battery power to operate, including powering the infrared illuminator which enhances brightness in low-light conditions.
This answer is automatically generated
@Andrew Lee How do I focus the the crosshairs on the nigh scope? Do I need to sight in during the night?