Figure 2-2. Battery Installation
2.1.2. INSTALLATION ON MIL-STD-1913 RAIL
PS-40
Light suppressor
Dayscope
Platform ring
Long Rail Adapter
Quick Release Mount
Figure 2-3. PS-40 Installed on MIL-STD-1913 Rail
forward of Dayscope
NOTE
The optical axis of the PS-40 and the riflescope should be
matched. Difference of the axes position more than 3 mm is not
recommended. Measure the height of the riflescope axis above
the rail. Observe table 1-2 for the sight axis height above the rail.
If the difference in the axis heights of the PS-40 and riflescope is
more than 3 mm it is necessary to replace riflescope mounting
rings or monoblock by proper ones.
Install the PS-40 on MIL-STD-1913 rail as follows:
A. Take off the output lens cap (see figure 1-1) and put it into the
storage case.
2-3