ATN NVG-7 Operator's Manual page 22

1. remove the already adjusted head mount from head.
2. loosen the screw, push the button a and insert the bracket of the
NVG-7 to the rail of the head mount.
3. place the head mount with NV unit onto your head.
4. You might want to adjust the vertical position of goggles over your
eyes and angle of tilt of looking axis. the straps of headgear can
be readjusted for it. then tighten the straps until the headgear fits
firmly.
5. move the unit along the rail for eye relief adjustment. tighten the
screw for fixing in position.
If you need to increase the eye relief of your goggles, you can dis-
place the bracket on the top of NVG-7.
1. Unscrew the screw and detach the end-cap from the bracket of
NVG-7.
2. Unscrew the 2 screws and detach the bracket from the NVG-7
body.
3. turn the bracket 180 degrees.
4. Screw the 2 screws back into place.
C. Flip-up Mechanism
the head mount has a flip-up mechanism. push the button B on the
side of the mount and lift the unit up until the unit fixates in the top po-
sition. push the same button to lower NV unit to viewing position.
2-4
FIGURE 2-5. MOUNTING OF THE BRACKET