Planet FSD-804PS User Manual page 23

This set command list contains nine items:
Set port [n]: Please refer to chapter 4.4.3.1.
Set trunk: Please refer to chapter 4.4.3.2.
Set vlan [n]: Please refer to chapter 4.4.3.3.
Set poe [n]: Please refer to chapter 4.4.3.4.
Set management vlan: Please refer to chapter 4.4.3.5
Set vlan mode: Please refer to chapter 4.4.3.6
Set pvid: Please refer to chapter 4.4.3.7
Set ip xxx.xxx.xxx.xxx.mmm.mmm.mmm.mmm.ggg.ggg.ggg.ggg: Please refer to chapter 4.4.3.8
Set pass: Please refer to chapter 4.4.3.9
4.4.3.1 Set port [n]
This command allows configuring per port parameters of FSD-804PS. the correct usage is shown as below:
Set port [n]: n=1-8, to configuring per port parameters of FSD-804PS. The configuring per port parameters screen in
Figure 4-19 appears and the detail description shown in table 4-2.
Object
Full Duplex Flow Control
Auto Negotiation
Speed
Duplex
IP TOS/802.1p Priority
Port-based Priority Mapping
Figure 4-19 Port Configuration screen
Description
Allow disable (off) or enable (on) flow control of each port.
Allow disable or enable Auto negotiation of each port.
Allow set per port run at 10Mbps or 100Mbps speed mode.
Allow set per port run at half or full duplex mode.
Allow disable or enable per port IP TOS/802.1p Priority function.
Allow assign low queue or high queue on each port.
Table 4-2 Descriptions of the Port Configuration screen Objects
- 23 -