Planet BM-2010A User Manual page 13

Manager is MDI port. Thus, you can just use straight network to connect the LAN port to your switch or
hub.
- Connect WAN Cable
Connect the router, DSL or Cable modem to the WAN port on Bandwidth Manager. The LAN and WAN port
of Bandwidth Manager are both MDI port. Thus, in some case, you may need to use cross-over cable to
connect your router, DSL or cable modem.
- Power Up
Connect the supplied power cord to Bandwidth Manager and use the power switch that in rear panel to turn
on the Bandwidth Manager. Use only the power cord provided. Using a different one may cause hardware
damage.
NOTE: Once you power on the Bandwidth Manager, it will start to beep indicated it is on by-pass mode.
This is normal and when the system stop to beep, the system booting is completed.
- Check the LEDs
The PWR LED should be ON. The STATUS LED should flash for about 1 to 2 minutes, then turn Off. This
LED will also flash when is reading data from the memory. Both the WAN and LAN's LNK LED should be
on. If one of the LED is off, please check the network connection. In some case, you may need to use
cross-over cable to connect the LAN or WAN port to your networks.
For more information, refer to Section 1.3 Bandwidth Manager Front View.
BM-2010A / BM-2100 Bandwidth Manager User's Manual
- 9 -